+- Muzykuj.com Forum (https://forum.muzykuj.com)
+-- Dział: Syntezatory (https://forum.muzykuj.com/forumdisplay.php?fid=23)
+--- Dział: KORG (https://forum.muzykuj.com/forumdisplay.php?fid=33)
+---- Dział: KRONOS / KRONOS X / KROME (https://forum.muzykuj.com/forumdisplay.php?fid=257)
+---- Wątek: podział klawiatury w korg krome (/showthread.php?tid=1163)
podział klawiatury w korg krome - kaamil - 03.04.2016
Witam. Czy ktoś wie jak podzielić klawiature w Korg Krome. MAm instrukcje ale tam nie ma nic "krok po kroku" znalazłem na necie cos takiego
Layering and splitting sounds across different sections of the KROME is made possible in Combination
mode (COMBI). You can zone up to 16 parts. In this example we will zone 4.
First, pick a combination to zone.
1. Press the COMBI button.
2. Let’s start out with a blank Combination, so press the D bank button, and then
enter 000 using the numbers on the right hand side of the keyboard.
3. Press the Enter button.
Now you can change the programs in this combination to the different sounds you want to use across the
keyboard.
4. Touch the Prog 1-8 tab at the bottom of the screen.
5. Using the touch screen, and/or rotary dial, select programs you wish to use in
parts 1-4 (i.e. A000 would be changed to B017).
You must now make sure all of the parts you chose are on, and that they are triggered by the same MIDI
channel.
6. Press the PAGE button
7. Touch “P3 Timbre Parameter” on the screen.
8. Touch each box in the “Status” section on the screen (1-4) and change it using the
rotary dial to read “INT” if it is not already set to “INT”.
9. Below the status section, make sure MIDI channels 1-4 read “Gch”.
10. Press the PAGE button.
11. Touch “P4 - Zone/Delay”
12. In the first column of the Combination on the screen, G9 (Top Key) will be highlighted by
default.
13. Press and hold the ENTER button while you play the highest note you wish to trigger that
particular sound (you will see the note change on the screen).
14. Touch the entry for “Bottom Key” on the screen to highlight it. By default, it will
be “C-1”.
15. Press and hold the ENTER button while you play the lowest note you wish to trigger that
particular sound (you will see the note change on the screen).
16. Repeat steps 12-15 for Combination parts 2, 3, and 4. Use the 2nd, 3rd, and 4th, columns this time,
as these correspond to Parts 2, 3, and 4.
17. Touch the top right hand drop-down menu arrow and select “Write Combination”.
18. Touch the “T” to rename the Combination.
19. After naming it, choose a category (and subcategory if you wish) to make it easier to find the
sound later.
20. Touch OK.
21. Press the Exit button.
Ale nic mi to nie pomaga, bo jak podziele klawiature na 4 częsci to gra mi tylko jedna barwa (ta pierwsza) a pozostała czesc klawiatury jest bez dźwięku. Pomocy!